C160工業汽輪機

C160INDUSTRIAL TURBINE

山東晨洋動力科技股份有限公司

Shandong Chenyang Power Technology Co., LTD

C160背壓式汽輪機是單級背壓式汽輪機，有一個復速級葉輪，葉輪節圓直徑為1600毫米，調速系統可采用日本光榮電子調速，也可采用woodward公司的TG17或TG13型機械調速器，主軸轉速為1000-1500轉/分。該機型主要特點就是利用低溫低壓的蒸汽作為汽源拖動旋轉機械做功實現能源的梯級利用以達到節能降耗的目的。

C160 backpressure turbine is single stage backpressure turbine. Its rotor uses a velocity-compounded stage impeller. Nozzle pitch diameter is 1600mm. Its speed regulating system can use KOEL electronic speed govering, and also can use woodward TG17 or TG13 mechanical governor.Its speed of main shaft is 1000-1500r/min. The main features of models is the use of low-temperature, low-pressure,low-differential pressure steam as steam source dragging turbo-dynamo doing work to realize the energy conservation.

如欲訂貨，請告知下列基本參數

1.       被拖動機械種類

2.       定購臺數

3.       要求的出軸功率

4.       被拖動機組的轉速及轉向

5.       蒸汽參數

（a）                      進汽壓力

（b）                      進汽溫度或過熱度

（c）                      排汽壓力

6.       蒸汽量

7.       要求的調整范圍及調節方式

8.       運行方式：連續、斷續或備用

9.       布置方式：單層或雙層，對進排汽方位的要求

10.       環境條件：室內或室外，周圍塵埃及危險氣體情況，氣壓及氣溫

11.       冷卻水條件：溫度、水質

12.       交貨日期及地點。

When ordering,please send us the following informations:

1. What kind of driven machinery to be used.

2. Number of units required.

3. Required output.

4. Required speed and direction of driven machinery.

5. Steam parameters:

   (a) Inlet pressure

   (b) Inlet temperature or superheat degree

   (c) Exhaust pressure

6. Desired steam consumption

7. Required speed regulating range and governing method.

8. Operation mode: Continuous, intermittent or spare.

9. Arrangement mode: Single-deck or double-deck, and requirements concerning the orientation of steam inlet and exhaust piping.

10. Ambient condition: Indoor or outdoor, conditions of dust and hazardous gas in air.atmospheric pressure and temperature.

11. Cooling water conditions: Temperature, water quality .

12.Date of delivery and destination.

縱剖面圖

VERTICAL SECTIONAL DRAWING

產品技術規格：

TECHNICAL SPECIFICATIONS OF THE PROUDUCT

注 進排汽壓力為絕對壓力，汽輪機本體重量8.5T

總布置圖

GENERAL-ARRANGEMENT DIAGRAM

熱力系統圖

THERAMAL ENERGYDIAGRAM